Join the 155,000+ IMP followers

www.foodpackautomation.com

Automated Poultry Tail Cutting in Cut-Up Lines

JBT Marel TailCutter HP separates chicken tails from saddles in ACM-NT cut-up lines, removing or harvesting tail meat consistently despite flock variations.

  marel.com
Automated Poultry Tail Cutting in Cut-Up Lines

In automated poultry cut-up lines, the tail must be separated cleanly from the saddle before anatomical leg processing, yet markets differ on whether the tail is a by-product or a valuable food ingredient. JBT Marel addresses both requirements with the TailCutter HP module for its ACM-NT cut-up line, which removes or harvests chicken tails automatically.

Tail removal ahead of anatomical leg processing
In some markets, the chicken tail is simply removed to allow precise anatomical leg cutting. In others, tail meat is an edible product that needs to be harvested carefully. In many cultures, particularly in Asia, Africa and parts of the Caribbean, chicken tails are eaten as snacks or appetizers, used in soups, dim sum and stir fries, or grilled on skewers, as with bonjiri yakitori in Japan.

Position in the ACM-NT cut-up line
The TailCutter HP is installed between the Breast Cap Cutter or Front/Back Half Cutter and the leg cutter. It separates the tail from the saddle automatically without damaging the tail or the thigh meat. The module works in combination with the ALPINE anatomic leg processor, which JBT Marel also showed at VIV Europe 2026, held from 2 to 4 June 2026 in Utrecht, the Netherlands.

How the module handles flock variations
Horizontal positioning of the product and two guides ensure a consistent cut regardless of carcass size. Once the module has been set up during installation, virtually no further adjustments are needed, even with wide flock variations or different breeds, and no skilled labour is required. The TailCutter HP processes back halves or saddles.

Configurable cutting point for market requirements
During installation, the exact cutting point between carcass and tail can be predefined to meet market requirements. Where the tail itself is considered a valuable product, more back skin can be left on the tail. When the market requires non-anatomical quarter legs, including split tail and spine, the TailCutter can be bypassed.

Operation, hygiene and maintenance
The TailCutter HP runs fully automatically, so no specialized operator is required, and knife replacement is simple. The module is easy to clean and has low maintenance requirements, which reduces downtime in high-speed ACM-NT cut-up lines. JBT Marel has not published throughput or yield figures for the module.

Additional Context
This section details technical specifications and competitive benchmarking not included in the original product announcement.

Automating secondary cuts such as tail removal is part of a wider trend in poultry processing to reduce dependence on manual labour at high line speeds and to keep yields consistent. Because carcass size within a flock can vary considerably, cutting modules that position each product mechanically rather than relying on fixed settings help maintain cut quality. No independent benchmark data are available for an objective comparison with tail-cutting modules from other poultry processing equipment suppliers.

Edited by Sucithra Mani, Induportals editor – adapted by AI.

www.jbtmarel.com

  Ask For More Information…

LinkedIn
Pinterest

Join the 155,000+ IMP followers